improve server replication performance by running multiple replicator
tasks simultaneously. By default, only one replicator task is executed.
With a single replicator task running, if you want to replicate with
multiple servers at the same time, the first replication must complete
before the next one can start. Set the number of replicators by adding
the following entry in the NOTES.INI file, where the value is the
number of replicators:
Replicators = [number]
All other factors aside, it is
recommend that you set the number of replicator tasks equal to the
number of spoke servers with which the hub replicates. However, you
should not exceed 20 replicators to avoid putting too much load on the
server. If the server you intended to replicate is not a hub server,
the recommended number of replicators should equal the number of
processors on the server.
Redbook:Domino Tuning Parameters in notes.ini