To install IBM® Lotus® Quickr™ on an IBM i system, you must first install and configure a compatible release of IBM Lotus Domino®. Add Lotus Quickr to the server, then enable the Lotus Dominoservlet engine and, if necessary, UTF-8 encoding for non-English content.
To perform a new installation of Lotus Quickr on IBM i, complete the following tasks as appropriate:
Preparing for a new installation of Lotus Quickr on IBM i
IBM Lotus Domino version 8.5.1 Fix Pack 3 Interim Fix 2 (if you need ECM integration) must be installed on the same system as IBM Lotus Quickr 8.5.
Preparing your TCP/IP configuration
Assign TCP/IP addresses exclusively to the IBM Lotus Quickr, IBM Lotus Domino, IBM Lotus Sametime®and HTTP servers, add a TCP/IP interface and host name, and verify the server configurations.
Installing and configuring a Lotus Domino server for Lotus Quickr
Before installing IBM Lotus Quickr, you must install a compatible release of IBM Lotus Domino and configure it for IBM Lotus Quickr.
Enabling the Lotus Domino servlet engine on IBM i
After you have installed or upgraded to IBM Lotus Quickr, you must enable the Lotus Domino servlet engine. The servlet engine must be enabled to use Lotus Quickr place administration and to ensure that the Lotus Quickr home page does not display empty.
Configuring multi-server single sign-on for IBM i
With multi-server single sign-on, users can log in to a server once and during that session access servers enabled for single sign-on in the DNS domain without providing names and passwords again.
Preparing to install Lotus Quickr from a downloaded image on IBM i
When installing IBM Lotus Quickr for IBM i from a downloaded image instead of from physical media, you run a series of IBM i commands to prepare the downloaded files for installation.
Pre-accepting the IBM Lotus Quickr software agreements before starting installation
To speed up installation on IBM i, you can "pre-accept" the IBM Lotus Quickr software agreements before starting installation.
Installing the IBM Lotus Quickr software on IBM i (required)
IBM Lotus Quickr can be installed on an IBM i system by running the RSTLICPGM command.
Adding Lotus Quickr to the Lotus Domino server
You can add IBM Lotus Quickr to an existing IBM Lotus Domino server for IBM i.
Enabling UTF-8 character encoding on servers storing translated content on IBM i
If you use any IBM Lotus Quickr server that stores content other than English, you must set up the server to generate output using UTF-8 encoding so that page content displays correctly in other languages.